Error 10 on UFSX description

when you perform an upgrade or downgrade flashing both versions use the UFS BOX, if you ever receive any error messages 10 at :0x01000000-0x0100ffff, 940207,process faild,repowering mobile?
this is often experienced when doing the Special flashing Nokia DCT4 and WD2

what happens if during a flashing and such a thing happen? Error 10 on UFS, you can bet damage to the CPU and flash IC is damaged, the percentage of damage to the IC Flash 85% and CPU 15%
so the level of damage is greater than the CPU flash IC, before an improvement is better maximize softwre hardware first, because if we repair the hardware directly would tinkat higher difficulties,maximize software do that is by replacing the firmware with another version or higher
and if you have to replace with other version but still Error 10, so before you make improvements in hardware
if you do hardware repairs follow the steps below:
1.Reball flash IC or in other words off flash IC and update his legs and attach it again
2.if it still does not work the first step you should replace it with a new flash IC
3.Reball CPU IC or in other words off CPU IC and update his legs and attach it again
4.if the third step is not successful, then the next step is to replace it with a new CPU.

for Spansion Flash IC, use the higher version of the UPP

good luck